A to D Converter Read Instruction - English
This is a sample video. To access the full content,
please
Login
- Questions posted on Forums
- OpenPLC with LDmicro Tutorials - English
-
State of Atemp
Madam/Sir,What's the state of YHeat and YFan when the Atemp's state is inbetween 800 to 900, I think there the previous state of either of the YHeat or YFan is retained. This means say if Astate's scroll bar's pointer is at 0 and YFan is On then for a value of Atemp's state inbetween 800&900 the State of YFan still remains 1 and YHeat's state is still 0 but in the ladder diagram the rung of both conditions viz. YHeat(R)-YFan(S) and YHeat(S)-YFan(R) becomes deenergized. How is this happening where any one of the state is remaining retained as pe set only condtion or say reset only condition but the rung is deenergized for both cases when the scroll bar's pointer of Atemp state is inbetween 800-900.
04-05M 20-30S sc256356
Answer last updated on: June 16, 2022, 11:44 a.m.
-
Which connectors are used there in powerpins?
Which connectors are used there in powerpins? Are they Relimate connectors? If yes then explain it in brief how it's different from other connector types say male or female berg connectors or screw terminals in terms of functioning?
08-09M 10-20S sc256356
Answer last updated on: June 15, 2022, 4:18 p.m.
-
1
Overview of OpenPLC with LDmicro -
2
Installation of LDmicro on Linux -
3
Installation of LDmicro on Windows -
4
Introduction to LDmicro -
5
Simulation and Compilation -
6
OpenPLC Mainboard -
7
Programming OpenPLC -
8
OpenPLC Traffic Light and Switchboard Modules -
9
Normal Coil -
10
Normal Contact -
11
Negated Coil and Negated Contact -
12
Implementing NOT and AND logic gates -
13
Implementing OR and XOR logic gates -
14
Internal Relay and Output pin -
15
SET and RESET Coils -
16
OneShot Instructions -
17
Arithmetic Instructions -
18
Move Instruction -
19
Compare Instructions -
20
TON and TOFF Instructions -
21
RTO Timer Instruction -
22
CTU Counter -
23
CTD Counter -
24
CTC Counter -
25
OpenPLC Heater module -
A to D Converter Read Instruction -
27
PWM Instruction
Questions posted on ST Forums:
1308 visits
Outline:
Connection of SMPS and USBasp to the Mainboard About Analog to Digital Converter Read instruction Working of this instruction using a simple analog example How to control the temperature of the resistor? About NTC thermistor Setting the required parameters in LDmicro Real-time simulation of ADC Connection pin details of Mainboard and Heater module Make hardware connections for the ADC using Heater module Demonstration of ADC working on hardware
| Width: | 828 | Height: | 622 |
|---|---|---|---|
| Duration: | 00:11:25 | Size: | 4.8 MB |
Show video info
