Unlock the Power of Open Source! The " Linux New " SWAYAM Plus Course is live now and about 2,500 learners have already registered for it.

If you are a registered learner, the forum page is now active. Visit the page and get all your questions answered.

Arduino Programming with Scilab and Xcos - English

This is a sample video. To access the full content,
please Login

4262 visits

  1. Instruction Sheet
  2. Installation Sheet
  3. Report Missing Component
  4. Post your Question on the Forum
Outline:
About Getting ready for Arduino FLOSS tutorial
Refer to chapter 3 of the e-book for installation of Arduino IDE and Scilab
Points to be noted before proceeding
Interfacing Arduino with Scilab
About Arduino-Scilab toolbox
Set the Scilab working directory to the toolbox folder
Run the scilab script to check whether the firmware is properly installed or not
Scilab program to read the status of the pushbutton and display it on the GUI
Xcos program to turn the LED on or off, depending on the pushbutton status
Important points to remember
Width:814 Height:604
Duration:00:10:15 Size:5.2 MB

Show video info

Pre-requisite

Introduction to Arduino

Script

Timed Script

Slides

  • Slides-Arduino-Scilab/
  • Slides-Arduino-Scilab/Arduino_scilab.tex
  • Slides-Arduino-Scilab/st-logo.png
  • Slides-Arduino-Scilab/Arduino_scilab.pdf